Panasonic MINAS E-series - Manual (Page 51)

51
[Preparations]
Preparations
(Set button)
(Mode switch button)
Execution Display
Example of
display
Selection Display
To parameter setting mode
Positional deviation
Rotation speed of motor
Torque output
Control mode
Input/output signal status
Error factor, history
Used by manufacturer
Warning
Regenerative load factor
Overload factor
Inertia ratio
Total number of feedback pulses
Total number of control pulses
Unusable
Unusable
Motor auto recognition
Selection of communication
(Deviation: 5 pulses)
(1000r/min)
(Torque output: 100%)
(Position control mode)
(Input signal No. 0: active)
(Currently no error)
(No warning)
(30% of permissible
regenerative power)
(Overload factor: 28%)
(Inertia ratio: 100%)
(Total feedback pulses: 50)
(Total control pulses: 10)
(Motor auto recognition
active)
(RS232C communication)
P.52
P.52
P.53
P.55
P.56
P.56
P.56
P.56
P.56
P.56
P.56
P.56
P.56
The display shifts in the arrow direction by pressing
, and in the reverse direction by pressing .
SET
S
MODE
M
Page 57
When power of the servo driver is turned on for the first time after the driver is purchased, appears on the
display (when the motor is stopped). If the indication on the display that appears after turning on power is to be
changed, change the initial setting of Pr01LED. For the details, refer to the parameter setting in each control mode.
Description
Reference
page
Monitoring Mode