Panasonic MINAS E-series - Manual (Page 13)

13
[Before Use]
Before Use Replacement Guidance
Parts replacement cycles depend on the actual operating conditions and how the equipment has been used.
Defective parts should be replaced or repaired immediately.
Prohibited
Dismantling for inspections or repairs should be done by our
company (or our sales agents).
Equipment
Driver
Motor
Part
Smoothing condenser
Aluminum electrolytic
capacitor on the print
board
Rush current
preventive relay
Rush current
preventive resistor
Cooling fan
Bearing
Oil seal
Encoder
Standard replacement
cycles (hour)
about 5 years
about 5 years
Approx. 100,000 cycles
(The life depends on the
actual operating
conditions.)
Approx. 20,000 cycles
(The life depends on the
actual operating
conditions.)
2 to 3 years
(10,000 to 30,000 hours)
3 to 5 years
(20,000 to 30,000 hours)
5000 hours
3 to 5 years
(20,000 to 30,000 hours)
10,000 hours
Remarks
The replacement cycles shown here
are just only for reference if any part
is found defective regardless of the
standard replacement cycles,
immediately replace it with a new
one.
Motor with Gear Speed reducer