Yaskawa AC Drive P1000 Bypass Technical Manual - Manual (Page 28)

1.3 Model Numbers and Nameplate Checks
Please perform the following tasks after receiving the P1000 Bypass
• Inspect the P1000 Bypass for damage.
If the P1000 Bypass appears damaged upon receipt, contact the shipper immediately.
• Verify receipt of the correct model by checking the information on the nameplate.
• If you have received the wrong model or the P1000 Bypass does not function properly, contact your supplier.
If you find any irregularities in the above items, contact the shipping company, the distributor or representative you purchased
the P1000 Bypass from or your Yaskawa office immediately. The P1000 Bypass is thoroughly tested at the factory. Any
damages or shortages evident when the equipment is received must be reported immediately to the commercial carrier that
transported the material. Shipping damage is not covered by the Yaskawa warranty. After unpacking and inspecting for damage,
verify that internal wire connections have not come loose during shipment by spot checking wire terminations with a
screwdriver or the appropriate tool. P1000 Bypass storage must be in a clean and dry location. Maintain the factory packaging
and provide covering as needed to protect the P1000 Bypass from construction site dirt, water, debris and traffic prior to and
during construction.
u Drive Nameplate
H
G
F
E
D
B
C
A
PRG : 8500
IND.CONT.EQ.
7J48 B
YASKAWA ELECTRIC CORPORATION Assembled in USA
: CIMR-PU2A0004FAA
PASS
MODEL
INPUT
OUTPUT
MASS
O / N
S / N
FILE NO
REV : A
: AC3PH 200-240V 50/60Hz 3. 9A
: AC3PH 0-240V 0-400Hz 3. 5A
: 3. 3 kg
:
:
: E131457 IP20
C/C CIMR-PU2A0004FAA :
6W3050-0-100 VAJ123456
J0073D207410100
A – Normal Duty Amps
B – Software version
C – Enclosure type
D – Serial number E – Lot number
F – Output specifications
G – Input specifications
H – AC drive model
Figure 1.1 Drive Nameplate Information Example
1.3 Model Numbers and Nameplate Checks
28 YASKAWA SIEP YAIP1B 01A YASKAWA AC Drive – P1000 Bypass Technical Manual