Yaskawa D1000 Series Power Regenerative Converter - Manual (Page 87)

4.2 Using the Digital Operator
YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual 87
S
ta
rt
-Up Pr
ogr
amming
&
O
p
er
at
io
n
4
4.2 Using the Digital Operator
Use the digital operator to enter Run and Stop commands, edit parameters, and display data including fault and alarm
information.
◆ LCD Display
Figure 4.1
Figure 4.1 LCD Display
Table 4.1 Display and Contents
No. Name Display Content
1 Operation Mode Menus
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
SETUP Displayed when in Setup Mode.
2 Mode Display Area
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
3 Ready Rdy Indicates the converter is ready to run.
4 Data Display – Displays specific data and operation data.
5
DC Bus Voltage
Reference
Assignment <1>
OPR Displayed when the DC Bus Voltage Reference is assigned to the LCD Operator Option.
AI Displayed when the DC Bus Voltage Reference is assigned to the Analog Input.
COM
Displayed when the DC Bus Voltage Reference is assigned to the MEMOBUS/Modbus
Communication Inputs.
OP Displayed when the DC Bus Voltage Reference is assigned to a Option converter.
6
LO/RE
Display <2>
RSEQ Displayed when the reference is supplied from a remote source.
LSEQ Displayed when the reference is supplied from the operator keypad.
RREF Displayed when the frequency reference is supplied from a remote source.
LREF Displayed when the frequency reference is supplied from the operator keypad.
7
Function Key 1
(F2)
HELP Pressing displays the Help menu.
← Pressing scrolls the cursor to the left.
HOME Pressing returns to the top menu (DC Bus Voltage Reference).
ESC Pressing returns to the previous display.
6
5
4
1 2 3
8 7
Volt Ref (OPR)
U1-51= 330V
U1-52= 330V
U1-53= 0.00A
- MODE - DRV Rdy
RSEQ
LREF
YAI
F2
F2
F2
F2
TOEP_C710656_07C_2_0.book 87 ページ ２０１５年１月９日 金曜日 午後６時２３分