Yaskawa D1000 Series Power Regenerative Converter - Manual (Page 35)

2.2 Mechanical Installation
YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual 35
Mec
h
an
ic
al
In
st
al
la
tio
n
2
■ Installation Types and Required Materials
The digital operator mounts to an enclosure two different ways:
• External/face-mount installs the operator outside the enclosure panel
• Internal/flush-mount installs the operator inside the enclosure panel
Table 2.2 Digital Operator Installation Methods and Required Tools
NOTICE: Prevent foreign matter such as metal shavings or wire clippings from falling into the drive or converter during installation and
project construction. Failure to comply could result in damage to the drive or converter. Place a temporary cover over the top of the
drive and converter during installation. Remove the temporary cover before drive and converter start-up, as the cover will reduce
ventilation and cause the drive or converter to overheat.
◆ Exterior and Mounting Dimensions
Use Table 2.3 to find the converter dimension drawings.
Table 2.3 Models and Types
Installation
Method
<1> If there are welding studs in the control panel, use the Installation Support Set B (for threaded studs).
Description
Installation
Support Sets
Model Required Tools
External/
Face-Mount
Simplified installation with the
digital operator is mounted on
the outside of the panel with
two screws.
– –
Phillips screwdriver
(#1)
Internal/
Flush-Mount
Encloses the digital operator in
the panel. The front of the
digital operator is flush with
the outside of the panel.
Installation Support Set A
(for mounting with screws through
holes in the panel)
EZZ020642A
Phillips screwdriver
(#1, #2)
Installation Support Set B
(for use with threaded studs that are
fixed to the panel) <1>
EZZ020642B
Phillips screwdriver (#1)
Wrench (7 mm)
Protective
Design
Converter Model
Page Three-Phase
200 V Class
Three-Phase
400 V Class
IP20/Open Type Enclosure
2A0005
2A0010
2A0020 4A0005
4A0010
4A0020
36
IP00/Open Type Enclosure
2A0030
2A0050
2A0065
2A0090
2A0130
4A0030
4A0040
4A0060
4A0100
4A0130
4A0185
4A0270
4A0370
4A0630
37
TOEP_C710656_07C_2_0.book 35 ページ ２０１５年１月９日 金曜日 午後６時２３分