O: operator-related settings – Yaskawa D1000 Series Power Regenerative Converter User Manual

Page 193

B.2 Parameter Tables

YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual

193

Par

ame

r Li

◆ o: Operator-Related Settings

The o parameters set up the digital operator displays.

L9-08

DC5 Conveter Unit
Replacement
Selection

Replacement DC5

Select when replacing DC5 with D1000, using the
peripheral devices as is.
0: Disable
1: Enable

Default: 0
Min.: 0
Max.: 1

L9-09

DC3 Conveter Unit
Replacement
Selection

Replacement DC3

Select when replacing DC3 with D1000, using the
peripheral devices as is.
0: Disable
1: Enable

Default: 0
Min.: 0
Max.: 1

<2> Default setting is dependent on parameter o2-04, Drive Model Selection.

No.

(Address

Hex)

Name

LCD Display

Description

Values

o1: Digital Operator Display Selection

o1-01

(500H)

Drive Mode
converter Monitor
Selection

User Monitor Sel

When the power supply is turned on, the operator will
display the following in order: DC Bus Voltage Reference,
DC Bus Voltage Feedback, DC Current Reference, Power
Supply Voltage, Power Supply Frequency, and U1-.
The o1-01 parameter sets the item to display instead of the
output voltage.
The o1-02 parameter sets the item to display at power up.

Default: 158
(Monitor U1-58)
Min.: 110
Max.: 914

o1-02

(501H)

User Monitor
Selection after
Power Up

Power-On Monitor
1: Frequency Ref
2: FWD/REV
3: Output Freq
4: Output Current
5: User Monitor

Selects the information displayed on the digital operator
when the power is turned on.
1: Output Voltage Reference
2: Output Voltage Feedback
3: Output Current
4: Input Voltage
5: User monitor item set in o1-01

Default: 1
Min.: 1
Max.: 5

o1-05

(504H)

<7>

LCD Contrast
Control

LCD Contrast

Sets the brightness of the LCD operator.

Default: 3
Min.: 0
Max.: 5

o2: Digital Operator Keypad Functions

o2-01

(505H)

LO/RE Key
Function Selection

LO/RE Key

0: Disabled
1: Enabled. LO/RE key switches between LOCAL and
REMOTE operation.

Default: 1
Min.: 0
Max.: 1

o2-02

(506H)

STOP Key Function
Selection

Oper STOP Key
0: Disabled
1: Enabled

0: Disabled. STOP key is disabled in REMOTE operation.
1: Enabled. STOP key is always enabled.

Default: 1
Min.: 0
Max.: 1

o2-03

(507H)

User Parameter
Default Value

User Default Sel
0: No Change
1: Save User Init
2: Clear User Init

0: No change.
1: Set defaults. Saves parameter settings as default values
for a User Initialization.
2: Clear all. Clears the default settings that have been
saved for a User Initialization.

Default: 0
Min.: 0
Max.: 2

o2-04

(508H)

Unit Model
Selection

Inverter Model #

Enter the converter model. Setting required only if
installing a new control board.

Default:
Determined by
converter model.
Min.: –
Max.: –