Yaskawa D1000 Series Power Regenerative Converter User Manual
Page 58
3.5 Terminal Cover
58
YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual
◆ Models 2A0030 to 2A0130, 4A0030 to 4A0370 (IP00/Open Type enclosure)
■
Removing the Terminal Cover
1.
Loosen the screws on the terminal cover, then pull forward on the terminal cover to free it from the converter.
Note: Models 2A0065 to 2A0130 and 4A0130 to 4A0630 have three mounting screws above the terminal cover.
CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal
cover may fall off causing an injury.
Larger capacity converters have large and heavy terminal covers. Remove and attach these covers with care.
Figure 3.19
Figure 3.19 Removing the Terminal Cover on an IP00/Open Type enclosure Model
■
Reattaching the Terminal Cover
After wiring the terminal board and other devices, double-check connections and reattach the terminal cover. Refer to
Wiring the Main Circuit Terminal on page 66
and
Wiring the Control Circuit Terminal on page 79
wiring.
Figure 3.20
<1> Connect ground wiring first, followed by the main circuit, and then wire the control circuit. Power lines and
signal wiring exit through the opening provided.
Figure 3.20 Reattaching the Terminal Cover on an IP00/Open Type enclosure Model
<1>
TOEP_C710656_07C_2_0.book 58 ページ ２０１５年１月９日 金曜日 午後６時２３分