Yaskawa D1000 Series Power Regenerative Converter - Manual (Page 130)

130 YASKAWA ELECTRIC TOEP C710656 07C YASKAWA Power Regenerative Converter - D1000 Instruction Manual
5.6 Copy Function Related Displays
5.6 Copy Function Related Displays
◆ Tasks, Errors, and Troubleshooting
The table below lists the messages and errors that may appear when using the Copy function. When executing the tasks
offered by the Copy function, the operator will indicate the task being performed. When an error occurs, a code appears
on the operator to indicate the error. Note that errors related to the Copy function do not trigger a multifunction output
terminal that has been set up to close when a fault or alarm occurs. To clear an error, simply press any key on the operator
and the error display will disappear.
Table 5.9 lists the corrective action that can be taken when an error occurs.
Note: 1. Whenever using the copy function, the converter should be fully stopped.
2. The converter will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to a converter when the voltage class, capacity, control mode, and software version match.
Table 5.9 Copy Function Task and Error Displays
Digital Operator Display Error Name
CoPy Writing Parameter Settings (flashing)
CPyE Error Writing Data
CSEr Copy Unit Error
dFPS Model Mismatch
End Task Complete
iFEr Communication Error
ndAT Model, Voltage Class, Capacity Mismatch
rdEr Error Reading Data
rEAd Reading Parameter Settings (flashing)
vAEr Voltage Class, Capacity Mismatch
vFyE Parameter settings in the converter and those saved to the copy function are not the same
vrFy Comparing Parameter Settings (flashing)
TOEP_C710656_07C_2_0.book 130 ページ ２０１５年１月９日 金曜日 午後６時２３分