Lcd display, Yea_common – Yaskawa CIMR-LU Drives User Manual
Page 57
4 Start-Up Programming & Operation
YASKAWA ELECTRIC TOEP C710616 38F YASKAWA AC Drive L1000A Quick Start Guide
57
S
tart-U
p
Prog
rammin
g
&
Op
er
at
io
n
4
■
LCD Display
Figure 33
Figure 33 LCD Display
Table 21 Display and Contents
12
ALM LED Light
Refer to ALARM (ALM) LED Displays on page 59
<1> The STOP key has highest priority. Pressing the STOP key will always cause the drive to stop the motor, even if an Up/Down command is
active at any external Up/Down command source. To disable the STOP key priority, set parameter o2-02 to 0.
<2> The LO/RE key can only switch between LOCAL and REMOTE when the drive is stopped. By default settings the LO/RE key function is
disabled. To allow using the LO/RE key for switching between LOCAL and REMOTE, set parameter o2-01 to 1.
No.
Name
Display
Content
1
Operation Mode Menus
MODE
Displayed when in Mode Selection.
MONITR
Displayed when in Monitor Mode.
VERIFY
Indicates the Verify Menu.
PRMSET
Displayed when in Parameter Setting Mode.
A.TUNE
Displayed during Auto-Tuning.
SETUP
Displayed when in Setup Mode.
2
Mode Display Area
DRV
Displayed when in Drive Mode.
PRG
Displayed when in Programming Mode.
3
Ready
Rdy
Indicates the drive is ready to run.
4
Data Display
–
Displays specific data and operation data.
5
Speed Reference Source
OPR
Displayed when the speed reference source is assigned to the LCD Operator.
COM
Displayed when the speed reference source is assigned to MEMOBUS/Modbus
Communication.
OP
Displayed when the speed reference is assigned to an option card.
6
LO/RE
Display
RSEQ
Displayed when the Up/Down command is supplied from a remote source.
LSEQ
Displayed when the Up/Down command is supplied from the operator keypad.
RREF
Displayed when the speed reference is supplied from a remote source.
LREF
Displayed when the speed reference is supplied from the operator keypad.
7
Function Key 1
(F1)
HELP
Pressing
displays the Help menu.
←
Pressing
scrolls the cursor to the left.
HOME
Pressing
returns to the top menu (Speed Reference).
ESC
Pressing
returns
to
the previous display.
8
FWD/REV
FWD
During Up command
REV
During Down command
No.
Display
Name
Function
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
RSEQ
LREF
FWD
FWD/REV
6
5
4
1
2
3
7
8
9
YEA_common
F1
F1
F1
F1
TOEP_C710616_38F_5_0.book 57 ページ 2013年12月4日 水曜日 午前9時56分