Terminal cover, Removing/reattaching the terminal cover, Yea_common – Yaskawa CIMR-LU Drives User Manual

Page 29

3 Electrical Installation

YASKAWA ELECTRIC TOEP C710616 38F YASKAWA AC Drive L1000A Quick Start Guide

ical

lat

◆ Terminal Cover

Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.

■

Removing/Reattaching the Terminal Cover

Removing the Terminal Cover
Models CIMR-LU2A0008 to 2A0075, 4A0005 to 4A0039, and 5A0003 to 5A0027

Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by drive model.

Figure 10

Figure 10 Removing the Terminal Cover

Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal
cover.

Figure 11

Figure 11 Removing the Terminal Cover

Models CIMR- LU2A0085 to 2A0415, 4A0045 to 4A0605, and 5A0003 to 5A0027

Loosen the screws on the terminal cover, then pull down on the cover.

CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal

cover may fall off causing an injury.

Note: The shape of the terminal covers and the numbers of screws differ depending on the drive models.

Figure 12

Figure 12 Removing the Terminal Cover

YEA_common

TOEP_C710616_38F_5_0.book 29 ページ２０１３年１２月４日　水曜日　午前９時５６分