Digital operator and front cover, Removing/reattaching the digital operator, Removing/reattaching the front cover – Yaskawa CIMR-LU Drives User Manual

Page 31: Yea_common

3 Electrical Installation

YASKAWA ELECTRIC TOEP C710616 38F YASKAWA AC Drive L1000A Quick Start Guide

ical

lat

◆ Digital Operator and Front Cover

Detach the digital operator from the drive for remote operation or when opening the front cover to install an option card.

Note: Be sure to remove the digital operator prior to opening or reattaching the front cover. Leaving the digital operator plugged into the

drive when removing the front cover can result in erroneous operation caused by a poor connection. Firmly fasten the front cover
back into place before reattaching the digital operator.

■

Removing/Reattaching the Digital Operator

Removing the Digital Operator

While pressing on the tab located on the right side of the digital operator, pull the digital operator forward to remove it
from the drive.

Figure 16

Figure 16 Removing the Digital Operator

Reattaching the Digital Operator

Insert the digital operator into the opening in the top cover while aligning it with the notches on the left side of the
opening.

Next, press gently on the right side of the operator until it clicks into place.

Figure 17

Figure 17 Reattaching the Digital Operator

■

Removing/Reattaching the Front Cover

Removing the Front Cover
Models CIMR- LU2A0008 to 2A0075, 4A0005 to 4A0039, and 5A0003 to 5A0027

After removing the terminal cover and the digital operator, loosen the screw that affixes the front cover (model CIMR-
LU2A0047, 4A0024, 4A0031, 5A0017, and 5A0022 does not use a screw to affix the front cover). Pinch inwards on the
tabs found on each side of the front cover, then pull forward to remove it from the drive.

Figure 18

Figure 18 Remove the Front Cover (Models CIMR-LU2A0008 to 2A0075, 4A0005 to 4A0039, and 5A0003 to 5A0027)

YEA_common

TOEP_C710616_38F_5_0.book 31 ページ２０１３年１２月４日　水曜日　午前９時５６分