Yaskawa iQpump1000 AC Drive Quick Start - Manual (Page 298)

7.1 Option Card Installation
This section provides instructions on installing option cards.
u Prior to Installing the Option
Prior to installing the option, wire the drive, make necessary connections to the drive terminals, and verify that the drive
functions normally without the option installed.
Table 7.1 below lists the number of options that can be connected to the drive and the drive ports for connecting those options.
Table 7.1 Option Installation
Option Port/Connector Number of Options Possible
AO-A3, DO-A3 CN5-A, B, C 1
SI-B3 <1> , SI-C3, SI-EN3 <1> , SI-EM3 <1> , SI-EP3 <1> , SI-ES3 <1> ,
SI-ET3 <1> , SI-N3, SI-P3, SI-S3, SI-T3, SI-W3 <1> , AI-A3 <2> ,
DI-A3 <2>
CN5-A 1
<1> Not available with models 4A0930 and 4A1200.
<2> When using AI-A3 and DI-A3 as monitors, the card can be connected to any of CN5-A, CN5-B or CN5-C. The input status of AI-A3 can then be
viewed using U1-21, U1-22, and U1-23, and the input status of DI-A3 can then be viewed using U1-17.
Figure 7.1 shows an exploded view of the drive with the option and related components for reference.
I
J
K M A
L
D
F
G
C
E
B
H
NS MS NS MS
TX RX
A – Drive front cover
B – HOA keypad
C – LED label (for communication
options)
D – Drive terminal cover
E – Removable tabs for wire routing
F – Included screws
G – Ground wire
H – Drive grounding terminal (FE)
I – Connector CN5-C
J – Connector CN5-B
K – Connector CN5-A
L – Insertion point for CN5 connector
M – Option
Figure 7.1 Drive Components with Option
7.1 Option Card Installation
298 YASKAWA TOEP YAIP1W 01B YASKAWA AC Drive - iQpump1000 Quick Start Guide