Yaskawa Yasnac PC NC - Manual (Page 325)

YASNAC PC NC Operating Manual APPENDIX 3: Parameter Tables
A3 - 99
Motion
Address Bit Description
Register
Units
Minimum
Value
Maximum
Value
Long Description
860 Deceleration feedrate by corner feedrate
"mm" mm/min 0 240000 Deceleration feedrate by cor-
ner feedrate designation func-
tion, “mm” mode (P)
861 Deceleration distance by corner feedrate
“mm” 0.001mm 0 999999999 Deceleration distance by cor-
ner feedrate designation func-
tion, “mm” mode (L)
862 Deceleration feedrate by corner feedrate
“inch” 0.1inch/min 0 94488 Deceleration feedrate by cor-
ner feedrate designation func-
tion, “inch” mode (P)
863 Deceleration distance by corner feedrate
“inch” 0.0001inch 0 393700787 Deceleration distance by cor-
ner feedrate designation func-
tion, “inch” mode (L)
1000 7 SAGR check when rapid to feed
0: Not checked
1: Checked
0 1 Checking of SAGR when feed
rate is changed from rapid to
feed
4015 3 In-position check at the completion of G04
1: Checked
0: Not checked
0 0
4 In-position check when G code is changed to
G00
0: Not checked
1: Checked
0 1
4461 1st axis overtravel distance in G60 0.001mm 0 32767
4462 2nd axis overtravel distance in G60 0.001mm 0 32767
4463 3rd axis overtravel distance in G60 0.001mm 0 32767
4464 4th axis overtravel distance in G60 0.001mm 0 32767
4465 5th axis overtravel distance in G60 0.001mm 0 32767
4820 Allowable error range when arc radius is
specified 0.001mm 0 999999999