Yaskawa Yasnac PC NC - Manual (Page 209)

YASNAC PC NC Operating Manual Appendix 2: Alarm Tables
A2 - 5
alarm.210 In user macro, the value of constant is outside the allowable range.
alarm.211 The number of cancel codes for G67 is too many.
alarm.212 There is an error in the format.
alarm.213 A value not defined as a variable number is used.
alarm.214 A variable used in replace statement is the variable which cannot be used for this operation.
alarm.215 The nesting level of “[ ]” exceeds the allowable limit.
alarm.216 The nesting level of macro program call exceeds the allowable limit.
alarm.217 DO - END is not used in pairs.
alarm.218 The numbers of brackets “[“ and ”]” do not agree with each other.
alarm.219 In “DO M”, 1 (M, 3 is not satisfied.)
alarm.220 In “GOTO n”, “n” is outside the allowable range or “n” is not found.
alarm.221 In a macro program, division by “O” is executed.
alarm.222 Square root of a negative value.
alarm.223 Floating point data exceeds the allowable range.
alarm.224 In modal call (G66), axis command is specified with M99 return designation.
alarm.225 Overflow has occurred with operation stack.
alarm.226 Execution of the following functions was impossible: ASIN, ACOS, LN, SQRT.
alarm.227 Overflow has occurred during conversion into integer.
alarm.228 Overflow has occurred with the input data for the BCD function.
alarm.229 There is an error in the format of the BIN function.
alarm.230 Overflow has occurred as the result of execution of the EXP function.
alarm.240 Reference point return has not been completed with the axis for which G29, G30 is designated.
alarm.241 Reference point return is invalid for the axis for which G28 is designated.
alarm.250 An illegal code has been designated in a solid tap program.
alarm.255 An C command is designated for the spindle in the spindle control mode.
alarm.256 An S command is designated for the spindle in the C-axis control mode.
alarm.260
*There is no P or Q command in the M98 block.& *There is no P command in the G65/G66, G25 block.&
*Both
G25 and M98/M99 are designated in the same block.
alarm.261 Nesting level of M98 subprogram call or G25 exceeds the allowable limit.
alarm.262
In a program that calls a micro program by G, M, or T code (M98, M99, G65, G66, G25), the designated pro-
gram number or sequence number is not found.
alarm.263
An attempt was made to start a program by executing address search after buffering subprogram or macro
call.
Alarm No. Description