H3C Technologies H3C Intelligent Management Center - Manual (Page 289)

273
The security check failure statistics are collected by account, service, and security check item. For
example, when an account encounters two security check failures on the same service and security check
item, the report considers them as one failure. However, when an account encounters two security check
failures on different services, , even if they are for the same security check item, the report considers them
as two failures.
Software installation report
This report collects statistics about software names and the number of assets with each type of software
installed for all registered assets in the specified asset group, including its subgroups. The report collects
statistics only about asset groups to which the current operator has privileges.
To view the software installation report:
1. Click the Report tab.
2. Click the Software Installation Report link in the My Real-Time Reports [Edit Mode] area. (Verify
that this link displays [Edit Mode], as this confirms that you are in view mode.)
The Set Parameter dialog box appears.
3. From the Asset Group list, select the asset group whose statistics are to be collected.
The system collects statistics about software names and the number of assets with each type of
software installed for all registered assets in the asset group, including its subgroups.
4. Click OK.
The software installation report appears in an Intelligent Analysis Report Viewer page, as shown
in
Figure 51 .
Figure 51 Software installation report
Software installation report parameters
• Report Time—Time when the report was generated.
• Group Name—Name of the asset group.
This report collects statistics about software names and the number of assets with each type of
software installed for all registered assets in the specified asset group, including its subgroups. All
indicates all asset groups. The report collects statistics about only asset groups to which the current
operator has privileges.