H3C Technologies H3C S12500 Series Switches - Manual (Page 85)

73
[ftp] get newest.bin
• Download the system software image file newest.bin from the PC to the Flash root directories of the
standby MPUs (any MPU except the active MPU of the IRF fabric). (Suppose the IRF fabric has three
standby MPUs: one in slot 1 of member device 1, one in slot 0 of member device 2, and one in slot
1 of member device 2.)
[ftp] get newest.bin chassis1#slot1#flash:/newest.bin
227 Entering Passive Mode (10,1,1,1,10,68).
125 BINARY mode data connection already open, transfer starting for
chassis1#slot1#flash:/newest.bin.
226 Transfer complete.
FTP: 23951480 byte(s) received in 95.399 second(s), 251.00K byte(s)/sec.
[ftp] get newest.bin chassis2#slot0#flash:/newest.bin
227 Entering Passive Mode (10,1,1,1,12,43).
125 BINARY mode data connection already open, transfer starting for
chassis2#slot0#flash:/newest.bin.
226 Transfer complete.
FTP: 23951480 byte(s) received in 95.399 second(s), 251.00K byte(s)/sec.
[ftp] get newest.bin chassis2#slot1#flash:/newest.bin
227 Entering Passive Mode (10,1,1,1,5,49).
125 BINARY mode data connection already open, transfer starting for
chassis2#slot1#flash:/newest.bin.
226 Transfer complete.
FTP: 23951480 byte(s) received in 95.399 second(s), 251.00K byte(s)/sec.
# Upload the configuration file config.cfg of the device to the server for backup.
[ftp] ascii
[ftp] put config.cfg back-config.cfg
227 Entering Passive Mode (10,1,1,1,4,2).
125 ASCII mode data connection already open, transfer starting for /config.cfg.
226 Transfer complete.
FTP: 3494 byte(s) sent in 5.646 second(s), 618.00 byte(s)/sec.
[ftp] bye
221 Server closing.
# Specify newest.bin as the main system software image file for the next startup of the active MPU of the
IRF fabric.
boot-loader file newest.bin chassis 1 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1
slot 0!
# Specify newest.bin as the main system software image file for the next startup of the standby MPUs of
the IRF fabric.
boot-loader file chassis1#slot1#flash:/newest.bin chassis 1 slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 1
slot 1!
boot-loader file chassis2#slot0#flash:/newest.bin chassis 2 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis 2
slot 0!