H3C Technologies H3C S12500 Series Switches - Manual (Page 59)

47
NMS login example
In this example, IMC is used as the NMS for illustration.
1. Configure the switch:
# Assign IP address 13.13.13.111/24 to VLAN-interface 1. Make sure the switch and the NMS
host can reach each other. (Details not shown.)
# Enter system view.
system-view
# Enable the SNMP agent.
[Sysname] snmp-agent
# Create an SNMP community and assign access rights.
[Sysname] snmp-agent sys-info version all
[Sysname] snmp-agent community read public
[Sysname] snmp-agent community write private
# Configure an SNMP group.
[Sysname] snmp-agent group v3 managev3group
# Add a user to the SNMP group.
[Sysname] snmp-agent usm-user v3 managev3user managev3group
2. Configure IMC:
a. On the PC, launch a browser, and enter http://192.168.4.112:8080/imc in the address bar.
(Suppose the IP address of IMC is 192.168.4.112.)
When you log in to IMC for the first time, you can use the default account with the username
admin and password admin. Be sure to change the password immediately after login. For
information about how to change the password, see IMC manuals, such as H3C Intelligent
Management Center Getting Started Guide.
b. On the login page, enter the username and password, and then click Login.
The IMC homepage appears.
c. Configure the switch in the IMC system. (Details not shown.)
The settings of the switch in the IMC system must match those of the switch. For more
information about NMS and SNMP agent configuration on IMC and the switch, see Network
Management and Monitoring Configuration Guide.
You can also add accounts with different rights for operators and perform other operations in
the IMC system. For more information about IMC, see IMC manuals.