Own in, Figure 4 – H3C Technologies H3C S12500 Series Switches User Manual
Page 35
23
Figure 4 Connecting a terminal to the console port
2.
Connect the RJ-45 connector of the console cable to the console port of the MPU of the switch. If
two MPUs are installed on the switch, log in through the console port on the active MPU (typically
with a smaller slot number) for the first login.
NOTE:
•
Identify the mark on the console port and make sure you are connecting to the correct port.
•
The serial ports on PCs do not support hot swapping. If the switch has been powered on, always
connect the console cable to the PC before connecting to the switch, and when you disconnect the
cable, first disconnect from the switch.
3.
If the PC is off, turn on the PC.
4.
Launch the terminal emulation program and configure the communication properties on the
terminal.
through
shows the configuration procedure on Windows XP HyperTerminal.
Make sure the port settings are the same as listed in
.
- H3C S12500-X Series Switches H3C S9800 Series Switches H3C S9500E Series Switches H3C S5560 Series Switches H3C S5130 Series Switches H3C S5120 Series Switches H3C SR8800 H3C SR6600-X H3C SR6600 H3C MSR 5600 H3C MSR 50 H3C MSR 3600 H3C MSR 30 H3C MSR 2600 H3C MSR 20-2X[40] H3C MSR 20-1X H3C MSR 930 H3C MSR 900 H3C WX3000E Series Wireless Switches H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA3600 Series Access Points H3C WA2600 Series WLAN Access Points H3C SecPath F5020 H3C SecPath F5040 H3C VMSG VFW1000 H3C S10500 Series Switches