H3C Technologies H3C S12500 Series Switches - Manual (Page 185)

173
The following gives an AC power supply ID allocation configuration example.
The configuration requirements are as follows:
• The switch has three AC power supplies. The system has allocated IDs for the AC power supplies
randomly.
• Follow the allocation scheme as shown in Figure 58 to allocate IDs for the AC power supplies
manually.
Figure 58 Allocation scheme
The configuration procedure is as follows:
1. Execute the power-supply led-blink command to identify the correspondence between the
randomly allocated IDs and the AC power supplies.
# Identify the location of the AC power supply with ID 1.
system-view
[Sysname] power-supply led-blink module 1 blink-time 5 delay-time 10
After the command is executed, you can see that the power supply in slot 3 blinks, and thus the ID
of the power supply in slot 3 is 1. Execute the power-supply led-blink command to identify the
correspondence between the other two AC power supplies and their IDs. The result is shown
in Figure 59 .
Figure 59 Randomly allocated AC power supply IDs
2. Use the power-supply module new-id to allocate IDs for AC power supplies according to Figure
58 .
system-view
[Sysname] power-supply module 3 1 2 new-id 1 3 5
Configuring temperature thresholds for a card
You can set the temperature threshold to monitor the temperature of a card.
The switch supports lower temperature threshold, warning temperature threshold, and alarming
temperature threshold.
• When the card temperature drops below the lower temperature threshold or reaches the warning
threshold, the device logs the event and outputs a log message and a trap.
• When the card temperature reaches the alarming threshold, the device logs the event and outputs
a log message and a trap repeatedly, and alerts users through the LED on the device panel.
To configure temperature thresholds for a card:
Step Command Remarks
1. Enter system view. system-view N/A