H3C Technologies H3C S12500 Series Switches - Manual (Page 222)

210
|<4> 3 |
|<5> 4 |
|<0> Exit |
============================================================================
2. To place the device in standalone mode, enter 1 to set the chassis ID to 0. To place the device in
IRF mode, select 1, 2, 3, or 4 as its member ID.
The asterisk sign (*) indicates the current setting. For more information about the standalone and
IRF mode and member ID, see IRF Configuration Guide.
Enter your choice(0-5): 3
Chassis ID has been changed to 2.
The current chassis ID is 2.
Changing the system operating mode
1. Enter 2 in the product-specific submenu.
Enter your choice(0-4):2
==========================================================
|Note:'*'indicates the current working mode |
| Change The Working Mode Accordingly |
|-------------------------------------------------|
|<1> Standard Mode* |
|<2> BridgeE Mode |
|<3> RouteE Mode |
|<4> Advance Mode |
|<5> Configurable Mode |
|<0> Exit |
Enter your choice(0-5):
2. Select an operating mode for the device.
The asterisk sign (*) indicates the current setting. For more information about system operating
modes, see "Managing the device."
Enter your choice(0-5): 1
================================================================
|Note:the current working mode is Standard Mode, Hybrid |
| Change The Hybrid state Accordingly |
|--------------------------------------------------------|
|<1> None Hybrid(Default)* |
|<2> Hybrid |
|<0> Exit |
============================================================================
Enter your choice(0-2):
Changing the PCL key
1. Enter 3 in the product-specific submenu.
Enter your choice(0-4): 3
===============================================================
|Note:'*'indicates the current PCL Key |
| Change The PCL Key Accordingly |
|-------------------------------------------------------|
|<1> IPv6 disable and advanced mode* |