H3C Technologies H3C S12500 Series Switches - Manual (Page 135)

123
# Download new-config.cfg to the active MPU of the subordinate switch.
copy new-config.cfg chassis2#slot0#flash:/new-config.cfg
copy new-config.cfg chassis2#slot1#flash:/new-config.cfg
# Download soft-version2.bin from the TFTP server to the master and subordinate switches.
tftp 2.2.2.2 get soft-version2.bin
...
File will be transferred in binary mode
Downloading file from remote TFTP server, please wait............
TFTP: 10058752 bytes received in 141 second(s)
File downloaded successfully.
copy soft-version2.bin chassis1#slot1#flash:/soft-version2.bin
copy soft-version2.bin chassis2#slot0#flash:/soft-version2.bin
copy soft-version2.bin chassis2#slot1#flash:/soft-version2.bin
# Specify new-config.cfg as the next-startup configuration file for all member switches of the IRF
fabric.
startup saved-configuration flash:/new-config.cfg
Please wait ...
Setting the master board ...
... Done!
Setting the slave board ...
Chassis 1 Slot 1:
Set next configuration file successfully.
Chassis 2 Slot 0:
Set next configuration file successfully.
Chassis 2 Slot 1:
Set next configuration file successfully.
# Specify soft-version2.bin as the startup system software image for all MPUs.
boot-loader file flash:/soft-version2.bin chassis 1 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis
1 slot 0!
boot-loader file chassis1#slot1#flash:/soft-version2.bin chassis 1 slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis
1 slot 1!
boot-loader file chassis2#slot0#flash:/soft-version2.bin chassis 2 slot 0 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis
2 slot 0!
boot-loader file chassis2#slot1#flash:/soft-version2.bin chassis 2 slot 1 main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on chassis
2 slot 1!
# Reboot the device to complete the upgrade.
reboot
3. Use the display version command to verify the upgrade. (Details not shown.)