NewTek TriCaster Studio - Manual (Page 285)

Page | 265
Load (Targa) File Sequence as Clip Alt + drag from Filebin
E.3.5 STORYBOARD ONLY – DRAG/DROP
Change in/out points
Alt + drag
Change in/out points… audio only Ctrl + Alt + drag
Slip and slide Shift + Alt + drag
Slip and slide; audio only Shift + Ctrl + Alt + drag
E.3.6 TIMELINE ONLY – DRAG/DROP
Change in and out points
Drag Crouton edge
Stretch (speed) Alt + drag edge
Slip and slide Shift + Alt + drag
Change length of Transition Drag Transition edge
Change in and out points of Transition Shift + drag Transition edge
Slip and slide Transition Shift + Alt + drag Transition
Set current time marker Shift + Click
Pan through project Right Click + Drag Left/Right
Zoom in/out of project Right Click + Drag Up/Down
Slowly pan or zoom project Ctrl + Right Click + drag
E.3.7 IN/OUT POINTS
Mark In/Out Point
I / O (or E / R)
Mark In/Out then review Shift + I / O
Clear In/Out Point D / F (or Alt + I / O)
Clear Both In and Out Points G (or Alt + P)
Go to In/Out Point Q / W
Pre-roll before In/Out and play Shift + Q / W
Adjust In point Q + Left/Right Arrow
Adjust Out Point W + Left/Right Arrow
(Note: if no clips are selected, the functions above apply to the clip nearest to Edit Line).