Grandstream UCM6510 User Manual - Manual (Page 92)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 91 of 313
If selected, the USB storage device needs to be plugged into the
UCM6510 and the firmware file must be put under a folder named
“ZC_firmware” in the USB storage root directory.
• Local SD Card Media
If selected, an SD card needs to be plugged into the UCM6510 and
the firmware file must be put under a folder named “ZC_firmware” in
the USB storage root directory.
Upgrade via
When URL is selected as firmware source, configure upgrade via TFTP,
HTTP or HTTPS.
Server Path
When URL is selected as firmware source, configure the firmware
upgrading server path.
File Prefix
When URL is selected as firmware source, configure the firmware file
prefix. If configured, only the firmware with the matching encrypted prefix
will be downloaded and flashed into the phone, if URL is selected as
firmware source.
File Postfix
When URL is selected as firmware source, configure the firmware file
postfix. If configured, only the configuration file with the matching
encrypted postfix will be downloaded and flashed into the phone.
Allow DHCP Option 43/66
If DHCP option 43 or 66 is enabled on the LAN side, the TFTP server can
be redirected.
Automatic Upgrade
If enabled, the end point device will automatically upgrade if a new
firmware is detected. Users can select automatic upgrading by day, by
week or by minute.
• By week
Once selected, specify the day of the week to check HTTP/TFTP
server for firmware upgrades or configuration files changes.
• By day
Once selected, specify the hour of the day to check the HTTP/TFTP
server for firmware upgrades or configuration files changes.
• By minute
Once selected, specify the interval X that the SIP end device will
request for new firmware every X minutes.
Firmware Upgrade Rule Specify how firmware upgrading and provisioning request to be sent.
Web Access
Admin Password Configure the administrator password for admin level login.
End-User Password Configure the end-user password for the end user level login.
Web Access Mode Select HTTP or HTTPS as the web access protocol.
Web Server Port Configure the port for web access. The valid range is 1 to 65535.