Grandstream UCM6510 User Manual - Manual (Page 117)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 116 of 313
• Specific time can be configured on the bottom of the extension
configuration dialog. Scroll down the add Time Condition for specific
time.
• Office Time and Holiday could be configured on page Settings->Time
Settings->Office Time/Holiday page.
CC Settings
Enable CC
If enabled, UCM6510 will automatically alert this extension when a called
party is available, given that a previous call to that party failed for some
reason. By default it’s disabled.
CC Mode
Two modes for Call Completion are supported:
• Normal: This extension is used as ordinary extension.
• For Trunk: This extension is registered from a PBX.
The default setting is “Normal”.
CC Max Agents
Configure the maximum number of CCSS agents which may be allocated
for this channel. In other words, this number serves as the maximum
number of CC requests this channel is allowed to make. The minimum
value is 1.
CC Max Monitors
Configure the maximum number of monitor structures which may be
created for this device. In other words, this number tells how many callers
may request CC services for a specific device at one time. The minimum
value is 1.
Ring Simultaneously
Ring Simultaneously
Enable this option to have an external number ring simultaneously along
with the extension. If a register trunk is used for outbound, the register
number will be used to be displayed for the external number as caller ID
number.
External Number
Set the external number to be rang simultaneously. ‘-’ is the connection
character which will be ignored.
Time Condition for Ring
Simultaneously
Ring the external number simultaneously along with the extension on the
basis of this time condition.
Other Settings
Ring Timeout
Configure the number of seconds to ring the user before the call is
forwarded to voicemail (voicemail is enabled) or hang up (voicemail is
disabled). If not specified, the default ring timeout is 60 seconds on the
UCM6510, which can be configured in the global ring timeout setting
under web GUI->Internal Options->IVR Prompt: General Preference. The
valid range is between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout