Grandstream UCM6510 User Manual - Manual (Page 70)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 69 of 313
Table 17: HTTP Server Settings
Redirect From Port 80
Enable or disable redirect from port 80. On the PBX, the default access
protocol is HTTPS and the default port number is 8089. When this option is
enabled, the access using HTTP with Port 80 will be redirected to HTTPS
with Port 8089. The default setting is "Enable".
Protocol Type
Select HTTP or HTTPS as the protocol to access the HTTP server. The
default setting is "HTTPS". This also defines whether to use HTTP or
HTTPS to download the config file in zero config as the UCM6510 is
served as HTTP/HTTPS server that has the device config files for zero
config.
Port
Specify port number to access the HTTP server. The default port number is
8089.
Once the change is saved, the web page will be redirected to the login page using the new URL. Enter the
username and password to login again.
EMAIL SETTINGS
The Email application on the UCM6510 can be used to send out alert event Emails, Fax (Fax-To-Email),
Voicemail (Voicemail-To-Email) and etc. The configuration parameters can be accessed via web
GUI->Settings->Email Settings.
Table 18: Email Settings
TLS Enable
Enable or disable TLS during transferring/submitting your Email to other
SMTP server. The default setting is "Yes".
Type
• MTA: Mail Transfer Agent. The Email will be sent from the configured
domain. When MTA is selected, there is no need to set up SMTP
server for it or no user login is required. However, the Emails sent from
MTA might be considered as spam by the target SMTP server.
• Client: Submit Emails to the SMTP server. A SMTP server is required
and users need login with correct credentials.
Domain Specify the domain name to be used in the Email when using type "MTA".
Server
Specify the SMTP server when using type "Client". For example, if using
Gmail as the SMTP server, you can configure it as smtp.gmail.com:465.
Username
Username is required when using type "Client". Normally it's the Email
address.
Password
Password to log in for the above Username (Email address) is required
when using type "Client".
Display Name Specify the display name in the FROM header in the Email.