Grandstream UCM6510 User Manual - Manual (Page 162)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 161 of 313
DATA TRUNK
The UCM6510 E1/T1/J1 interface also supports data trunk function that allows users to access Internet.
Users can select HDLC, HDLC-ETH, Cisco and PPP protocol for the data trunk.
To use data trunk,
1. Go to web UI->PBX->Ports Config->Digital Hardware page and click to create a new group.
Designate a channel for data trunk usage in the group setting.
2. Go to web UI->PBX->Basic/Call Routes->Data Trunks page, click on to edit the data trunk.
3. Save the configuration and click on “Apply Changes” for the change to take effect.
4. Once connected, the data trunk will periodically ping and check the status, with status indicator shown
for the data trunk on the web page. The status indicator shows if connected successfully.
5. If the user happens to lost connection or experience unstable connection, click on to reconnect
to help resolve the problem.
6. Users can always click on ON/OFF switch in the web page to enable/disable the
configured data trunk.
Figure 89: Data Trunk Web Page
Figure 90: Data Trunk Configuration