Grandstream UCM6510 User Manual - Manual (Page 118)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 117 of 313
used is the shortest time set by either device.
Auto Record
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files can be accessed under web
GUI->CDR->Recording Files.
Skip Trunk Auth
· If set to ‘yes’, users can skip entering the password when making
outbound calls.
· If set to ‘By Time’, users can skip entering the password when making
outbound calls during the selected time condition.
· If set to ‘No’, users will be asked to enter the password when making
outbound calls.
Time Condition for Skip Trunk
Auth
If ‘Skip Trunk Auth’ is set to ‘By Time’, select a time condition during which
users can skip entering password when making outbound calls.
Dial Trunk Password Configure personal password when making outbound calls via trunk.
Table 34: SIP Extension Configuration Parameters - Specific Time
Specific Time
Time Condition Click to add Time Condition to configure specific time for this extension.
CREATE NEW IAX EXTENSION
The UCM6510 supports Inter-Asterisk eXchange (IAX) protocol. IAX is used for transporting VoIP
telephony sessions between servers and terminal devices. IAX is similar to SIP but also has its own
characteristic. For more information, please refer to RFC5465.
To manually create new IAX user, go to web GUI->PBX->Basic/Call Routes->Extensions. Click on
"Create New IAX Extension" and a new dialog window will show for users to fill in the extension
information. The configuration parameters are as follows.
Table 35: IAX Extension Configuration Parameters - Basic Settings
General
Extension The extension number associated with the user.
CallerID Number
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Permission Assign permission level to the user. The available permissions are