beautypg.com

Table 31: sip, Extension configuration parameters, Table 31: sip extension configuration – Grandstream UCM6510 User Manual User Manual

Page 113: Parameters

background image

Firmware Version 1.0.2.5

UCM6510 IP PBX User Manual

Page 112 of 313

The configuration parameters are as follows.

Table 31: SIP Extension Configuration Parameters - Basic Settings

General

Extension

The extension number associated with the user.

CallerID Number

Configure the CallerID Number that would be applied for outbound calls

from this user.

Note:

The ability to manipulate your outbound Caller ID may be limited by your

VoIP provider.

Permission

Assign permission level to the user. The available permissions are

"Internal", "Local", "National" and "International" from the lowest level to

the highest level. The default setting is "Internal".

Note:

Users need to have the same level as or higher level than an outbound

rule's privilege in order to make outbound calls using this rule.

SIP/IAX Password

Configure the password for the user. A random secure password will be

automatically generated. It is recommended to use this password for

security purpose.

Support Hot-Desking Mode

If enabled, SIP Password will accept only alphabet characters and digits;

AuthID will be changed to the same as Extension.

Auth ID

Configure the authentication ID for the user. If not configured, the

extension number will be used for authentication.

Enable Voicemail

Enable voicemail for the user. The default setting is "Yes".

Voicemail Password

Configure voicemail password (digits only) for the user to access the

voicemail box. A random numeric password is automatically generated. It

is recommended to use the random generated password for security

purpose.

Skip Voicemail Password

Verification

When user dials voicemail code, the password verification IVR is skipped.

If enabled, this would allow one-button voicemail access. By default this

option is disabled.

Disable This Extension

If selected, this extension will be disabled on the UCM6510.

Note:

The disabled extension still exists on the PBX but can’t be used on the

end device.

Enable LDAP

If enabled, this extension will be added to LDAP Phonebook PBX list; if

disabled, this extension will be skipped when creating LDAP Phonebook.