Grandstream UCM6510 User Manual - Manual (Page 184)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 183 of 313
• Extension
• Voicemail
• Conference Room
• Call Queue
• Ring Group
• Paging/Intercom
• Voicemail Group
• Fax
• DISA
• IVR
• By DID
When "By DID" is used, the UCM6510 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination". If the dialed number matches the DID pattern, the call will
be allowed to go through.
• Dial By Name
Strip
Specify the number of digits to strip from the beginning of the DID. This is
used when "By DID" is selected in "Default Destination".
Prepend
Specify the digits to be prepended before the call is placed via the trunk.
Those digits will be prepended after the dialing number is stripped.
Prepend Trunk Name
If enabled, the trunk name will be added to the caller id name as the
displayed caller id name.
Dial Trunk
Configure to allow the inbound call to dial out from the PBX's trunk or not.
The default setting is disabled. Please be aware of potential security risk if
"Dial Trunk" is enabled. The inbound call might be able to dial out
international calls from the PBX's trunk if allowed by the privilege level.
DID Destination
Select the DID destination if "By DID" is selected in "Default Destination".
Only the selected category can be reached by DID using this inbound
route.
• Extension
• Conference
• Call Queue
• Ring Group
• Paging/Intercom Group
• IVR
• Voicemail Groups
• Fax Extension