Grandstream UCM6510 User Manual - Manual (Page 208)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 207 of 313
RING GROUP
The UCM6510 supports ring group feature with different ring strategies applied to the ring group members.
This section describes the ring group configuration on the UCM6510.
CONFIGURE RING GROUP
Ring group settings can be accessed via web GUI->PBX->Call Features->Ring Group.
Figure 110: Ring Group
• Click on "Create New Ring Group" to add ring group.
• Click on
to edit the ring group. The following table shows the ring group configuration parameters.
• Click on
to delete the ring group.
Table 72: Ring Group Parameters
Ring Group Name
Configure ring group name to identify the ring group. Letters, digits, _ and -
are allowed.
Extension Configure the ring group extension.
Ring Group Members
Select available users from the left side to the ring group member list on
the right side. Click on to arrange the order.
Ring Strategy
Select the ring strategy. The default setting is "Ring in order".
• Ring simultaneously
Ring all the members at the same time when there is incoming call to
the ring group extension. If any of the member answers the call, it will
stop ringing.
• Ring in order
Ring the members with the order configured in ring group list. If the first
member doesn't answer the call, it will stop ringing the first member
and start ringing the second member.
Permission
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Custom Prompt This option allows user to customize prompt for a ring group to announce