Grandstream UCM6510 User Manual - Manual (Page 220)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 219 of 313
PICKUP GROUPS
The UCM6510 supports pickup group feature which allows users to pick up incoming calls for other
extensions if they are in the same pickup group, by dialing "Pickup Extension" feature code (by default *8).
CONFIGURE PICKUP GROUPS
Pickup groups can be configured via web GUI->PBX->Call Features->Pickup Groups.
• Click on "Create New Pickup Group" to create a new pickup group.
• Click on
to edit the pickup group.
Select extensions from the list on the left side to the right side.
Figure 121: Edit Pickup Group
• Click on
to delete the pickup group.
CONFIGURE PICKUP FEATURE CODE
When picking up the call for the pickup group member, the user only needs to dial the pickup feature code.
It’s not necessary to add the extension number after the pickup feature code. The pickup feature code is
configurable under Web GUI->PBX->Internal Options->Feature Codes.
The default pickup feature code is *8.