Grandstream UCM6510 User Manual - Manual (Page 51)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 50 of 313
Figure 21: UCM6510 Using 802.1X EAP-MD5
The following table shows the configuration parameters for 802.1X on UCM6510. Identity and MD5
password are required for authentication, which should be provided by the network administrator obtained
from the RADIUS server. If “EAP-TLS” or “EAP-PEAPv0/MSCHAPv2” is used as the 802.1X mode, users
will also need upload 802.1X CA Certificate and 802.1X Client Certificate, which should be also generated
from the RADIUS server.
Table 9: UCM6510 Network Settings->802.1X
802.1X Mode
Select 802.1X mode. The default setting is "Disable". The supported 802.1X mode
are:
• EAP-MD5
• EAP-TLS
• EAP-PEAPv0/MSCHAPv2
Identity Enter 802.1X mode identity information.
MD5 Password Enter 802.1X mode MD5 password information.
802.1X CA Certificate Select 802.1X certificate from local PC and then upload.
802.1X Client
Certificate
Select 802.1X client certificate from local PC and then upload.
STATIC ROUTES
A static route is a pre-determined path that the network traffic travels to reach a specific host or network.
On the UCM6510, the static route function allows the device to use manually configured routes, rather than
dynamically assigned routes or default gateway configured in the UCM6510 web GUI->Network
Settings->Basic Settings to forward traffic. It can be used to define a route when no other routes is