Grandstream UCM6510 User Manual - Manual (Page 252)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 251 of 313
•
Feature Misc
Feature Code Digits Timeout
• Default Setting: 1000.
• Configure the maximum interval (in milliseconds) between the
digits input to activate the feature code.
Call Park
• Default Extension: 700.
• During an active call, initiate blind transfer and then enter this
code to park the call.
Parked Lots
• Default Extension: 701-720.
• These are the extensions where the calls will be parked, i.e.,
parking lots that the parked calls can be retrieved.
Use parklot as extension
If checked, the parklot number will be used as extension, you can
transfer to the parklot number for parking your call. If the parking lots
overlap existing extensions, there will be conflict.
Parking Timeout (s)
• Default setting: 300.
• This is the timeout allowed for a call to be parked. After the
timeout, if the call is not picked up, the extension who parks the
call will be called back.
Feature Codes
Voicemail Access Code
• Default Code: *98.
• Enter *98 and follow the voice prompt. Or dial *98 followed by
the extension and # to access the entered extension's voicemail
box.
My Voicemail
• Default Code: *97.
• Press *97 to access the voicemail box.
Agent Pause
• Default Code: *83.
• Pause the agent in all call queues.
Agent Unpause
• Default Code: *84.
• Unpause the agent in all call queues.
Paging Prefix
• Default Code: *81.
• To page an extension, enter the code followed by the extension
number.
Intercom Prefix
• Default Code: *80.
• To intercom an extension, enter the code followed by the
extension number.
Blacklist Add
• Default Code: *40.
• To add a number to blacklist for inbound route, dial *40 and
follow the voice prompt to enter the number.