Grandstream UCM6510 User Manual - Manual (Page 253)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 252 of 313
Blacklist Remove
• Default Code: *41.
• To remove a number from current blacklist for inbound route, dial
*41 and follow the voice prompt to remove the number.
Call Pickup on Ringing
• Default Code: **.
• To pick up a call for any extension xxxx, enter the code followed
by the extension number xxxx.
Pickup Extension
• Default Code: *8.
• This code is for the pickup group which can be assigned for
each extension on the extension configuration page.
• If there is an incoming call to an extension, the other extensions
within the same pickup group can dial *8 directly to pick up the
call.
Direct Dial Voicemail Prefix
• Default Code: *
• This code is for the user to directly dial or transfer to an
extension's voicemail.
• For example, directly dial *5000 will have to call go into the
extension 5000's voicemail. If the user would like to transfer the
call to the extension 5000's voicemail, enter *5000 as the
transfer target number.
Call Completion Request
• Default Code: *11
• This code is for the user who wants to use Call Completion to
complete a call.
Call Completion Cancel
• Default Code: *12
• This code is for the user who wants to cancel Call Completion
request.
Enable Spy • Check this box to enable spy feature codes.
Listen Spy
• This is the feature code to listen in on a call to monitor
performance. Monitor’s line will be muted, and neither party will
hear from the monitor’s extension. The default setting is *54.
Whisper Spy
• This is the feature code to speak to one side of the call (for
example, whisper to employees to help them handle a call). Only
one side will be able to hear from the monitor’s extension. The
default setting is *55.
Barge Spy
• This is the feature code to join in on the call to assist both
parties. The default setting is *56.