Grandstream UCM6510 User Manual - Manual (Page 45)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 44 of 313
Table 7: Change Binding Email option
Enter the password of
the account
Enter the current login user credential for UCM6510
Email Address Email Address is used to retrieve password when password is lost
NETWORK SETTINGS
After successfully connecting the UCM6510 to the network for the first time, users could log in the web GUI
and go to Settings->Network Settings to configure the network parameters for the device. Select each
tab in web GUI->Settings->Network Settings page to configure LAN/WAN settings, 802.1X and Port
Forwarding.
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
To connect the UCM6510 to network, T1/E1/J1 data trunk can also be used, instead of using the
WAN/LAN port. Please see section [DATA TRUNK] to use UCM6510 data trunk to connect the device to
Internet.
--------------------------------------------------------------------------------------------------------------------------------------------
BASIC SETTINGS
Please refer to the following tables for basic network configuration parameters on the UCM6510.
Table 8: UCM6510 Network Settings->Basic Settings
Method
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6510. The
default setting is "Route".
• Route
WAN port interface will be used for uplink connection. LAN port interface will be
used to serve as router.
• Switch
WAN port interface will be used for uplink connection. LAN port interface will be
used as bridge for PC connection.
• Dual
Both ports can be used for uplink connection. Users will need assign LAN 1 or
LAN 2 as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface if static IP is used for the interface.
Preferred DNS Server Enter the preferred DNS server address. If Preferred DNS is configured, the