Pri/ss7/mfc/r2 signaling trace, Analog record trace, Figure 185: troubleshooting analog trunks – Grandstream UCM6510 User Manual User Manual

Page 310

Firmware Version 1.0.2.5

UCM6510 IP PBX User Manual

Page 309 of 313

PRI/SS7/MFC/R2 SIGNALING TRACE

Please see section

ANALOG RECORD TRACE

Analog record trace can be used to troubleshoot analog trunk issue, for example, the UCM6510 user has

caller ID issue for incoming call from Analog trunk. Users can access analog record trance under web

GUI->Maintenance->Troubleshooting ->Analog Record Trace.

Here is the step to capture trace:

1. Select FXO or FXS for "Record Ports". If the issue happens on FXO 1, select FXO port 1 to record the

trace.

2. Select "Record Direction".

3. Select "Record File Mode" to separate the record per direction or mix.

4. Click on "Start".

5. Make a call via the analog port that has the issue.

6. Once done, click on "Stop".

7. Click on "Download" to download the analog record trace.

Figure 185: Troubleshooting Analog Trunks