Grandstream UCM6510 User Manual - Manual (Page 215)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 214 of 313
The default setting is "Ring All".
Music On Hold
Select the Music On Hold class for the call queue.
Note:
Music On Hold classes can be managed from web GUI-> PBX->Internal
Options->Music On Hold.
Leave When Empty
Configure whether the callers will be disconnected from the queue or not if
the queue has no agent anymore. The default setting is "Strict".
• Yes
Callers will be disconnected from the queue if all agents are paused or
invalid.
• No
Never disconnect the callers from the queue when the queue is empty.
• Strict
Callers will be disconnected from the queue if all agents are paused,
invalid or unavailable.
Dial in Empty Queue
Configure whether the callers can dial into a call queue if the queue has no
agent. The default setting is "No".
• Yes
Callers can always dial into a call queue.
• No
Callers cannot dial into a queue if all agents are paused or invalid.
• Strict
Callers cannot dial into a queue if the agents are paused, invalid or
unavailable.
Permission
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Dynamic Login Password
If enabled, the configured PIN number is required for dynamic agent to log
in. The default setting is disabled.
Ring Time Out
Configure the number of seconds an agent will ring before the call goes to
the next agent. The default setting is 15 seconds.
Wrapup Time
Configure the number of seconds before a new call can ring the queue
after the last call on the agent is completed. If set to 0, there will be no
delay between calls to the queue. The default setting is 15 seconds.
Max Queue Length
Configure the maximum number of calls to be queued at once. This
number does not include calls that have been connected with agents. It
only includes calls not connected yet. The default setting is 0, which means