Grandstream UCM6510 User Manual - Manual (Page 163)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 162 of 313
Table 55: Data Trunk Configuration Parameters
Data Enable
Select the checkbox to enable/disable data trunk. Users can also click on
the ON/OFF switch in data trunk web page to enable/disable this.
Channel Group
Select the digital channel group from the dropdown list to be used for data
trunk. Users will need create a new group under web UI->PBX->Ports
Config->Digital Hardware page for this purpose.
Encapsulation
Select the protocol used for the data trunk. The UCM6510 supports HDLC,
HDLC-ETH, PPP, Cisco and Frame Relay.
Local IP
Configure the local IP address for the data port. This IP address shouldn’t
conflict with the WAN or LAN side IP of the UCM6510.
Subnet Mask Configure the subnet mask for the data port.
Remote IP
Configure the remote IP address for the data port. This IP will be the
gateway IP address if “Default Interface” is enabled for the datat trunk.
DNS Server 1 Configure DNS server 1.
DNS Server 2 Configure DNS server 2.
Default Interface
If enabled, this data port will be used as the default interface for Internet
connection. The “Remote IP” will be the gateway IP address. This has
higher priority than the “Default Interface” assignment (LAN 1 or LAN 2)
under web UI->Settings if “Dual” is selected as the network method.