Grandstream UCM6510 User Manual - Manual (Page 250)

Firmware Version 1.0.2.5 UCM6510 IP PBX User Manual Page 249 of 313
CALL FEATURES
The UCM6510 supports call recording, transfer, call forward, call park and other call features via feature
code. Feature Codes settings can be found at web GUI->PBX->Internal Options->Feature Codes. This
section lists all the feature codes in the UCM6510 and describes how to use the call features.
FEATURE CODES
Table 81: UCM6510 Feature Codes
Feature Maps
Blind Transfer
• Default code: #1.
• Enter the code during active call. After hearing "Transfer", you
will hear dial tone. Enter the number to transfer to. Then the user
will be disconnected and transfer is completed.
• Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
Attended Transfer
• Default code: *2.
• Enter the code during active call. After hearing "Transfer", you
will hear the dial tone. Enter the number to transfer to and the
user will be connected to this number. Hang up the call to
complete the attended transfer.
• Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
Disconnect
• Default code: *0.
• Enter the code during active call. It will disconnect the call.
• Options
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
Call Park
• Default code: #72.
• Enter the code during active call to park the call.