Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 89)

Functional Description
ATCA-7350 Installation and Use (6806800G59G) 89
4.6.6 Fiber Channel (ATCA-7350 with RTM-ATCA-7350)
The ATCA-7350 with RTM-ATCA-7350 can provide two external Fiber channel ports through
the RTM, with one external FC daughter card configured (installed on connectors J1 of RTM-
ATCA-7350).
Please refer to RTM-ATCA-7350 Installation and Use manual.
4.6.7 Fiber Channel (ATCA-7350 with RTM-ATCA-7150)
The ATCA-7350 with RTM-ATCA-7150 can provide two or four external Fiber channel ports
through the RTM, with one or two external FC daughter cards configured (installed on
connectors J2, J4 of RTM-ATCA-7150).
Please refer to RTM-ATCA-7150 Installation and Use manual.
4.6.8 SAS HDD
The ATCA-7350 supports two hot-swappable RAID1 2.5 inch SAS/SATA HDD. The SAS
controller is SAS1064 chip of LSI for providing 3.0 G SAS interfaces.
4.6.9 SAS Port
The panel of the ATCA-7350 provides two external SAS port (3.0 Gbit/s) for connecting to
JBOD.
 Provides two fully independent phys.
 Support 3.0 Gbit/s and 1.5 Gbit/s SAS data transfers for each phy.
 Support SSP to enable communication with other SAS devices.
 Support SMP to communicate topology management information.
 Provides a serial, point-to-point, enterprise-level storage interface.
 Simplifies cabling interface that supports up to 128 devices through multiple expanders (if
available in external storage array).
 Supports wide ports consisting of two phys.
 Transfers data using SCSI information units.