Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 25)

Introduction
ATCA-7350 Installation and Use (6806800G59G) 25
1.3 Ordering Information
When ordering board variants or board accessories, use the order numbers given on the
following pages.
1.3.1 Supported Board Models
The following table explains the product nomenclature used for the available board variants.
1. The blade does not fulfill the "Unpacked Equipment Shock Criteria" as defined in NEBS GR63 4.3.2. During tests
which consisted of dropping the blade from 100 mm height, we observed that on some blades the AdvancedTCA
zone 2 and 3 connectors got damaged. Although it was possible to manually repair the connectors and the blade was
fully functional again afterwards, the criteria imposed by the NEBS standard were not fulfilled.
2. Some PICMG requirements are not fully met. Refer ATCA-7350/RTM-ATCA-7350 Release Notes for more
information.
Table 1-3 Product Nomenclature
Order Number Description
ATCA-7350-0GB
ATCA-7350-0GB-CK 1 ATCA PROCESSOR BLADE, DUAL HARPERTOWN, QUAD CORE (2.13 GHZ),
0GB, 10G SUPPORT, 2 HDD/SSD SLOTS (ROHS 5/6)
RTM-ATCA-7350 RTM FOR THE ATCA-7350 BLADE WITH 10G FABRIC SUPPORT (ROHS 5/6)
RTM-ATCA-7350-GE RTM FOR THE ATCA-7350 BLADE WITH 2 GE INTERFACES (ROHS 5/6)
RTM-ATCA-7350-2GE RTM FOR THE ATCA-7350 BLADE WITH 4 GE INTERFACES (ROHS 5/6)
RTM-ATCA-7350-FC RTM FOR THE ATCA-7350 BLADE WITH 2 FC INTERFACES (ROHS 5/6)
RTM-ATCA-7150-GE RTM FOR THE ATCA-7150 BLADE WITH 2 GE INTERFACES (ROHS 5/6)
RTM-ATCA-7150-GE-FC RTM FOR THE ATCA-7150 BLADE WITH 2 GE AND 2 FC INTERFACES (ROHS 5/6)
MEZC-RTM-7150-GE MEZZANINE CARD WITH 2 GE INTERFACES (ROHS 5/6)
MEZC-RTM-7150-FC MEZZANINE CARD WITH 2 FC INTERFACES (ROHS 5/6)
ATCA-7x50-MEM-2G
ATCA-7x50-MEM-2G-F 1 2 GB FBD MEMORY MODULE FOR ATCA-7X50 (ROHS 6/6)
ATCA-7x50-MEM-4G
ATCA-7x50-MEM-4G-F 1 4 GB FBD MEMORY MODULE FOR ATCA-7X50 (ROHS 6/6)