Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 67)

Controls, LEDs and Connectors
ATCA-7350 Installation and Use (6806800G59G) 67
All the tx/rx signals are defined from ATCA-7350 side.
3.4.1.3 Zone 3 Connectors
Zone 3 is composed of three connectors, J15, J29, and J31. The three connectors are used to
connect RTMs with ATCA-7350s. Zone 3 defines the following signals:
 USB (USB)
 VGA
 IPMC SMBus
 Power (VCC 12VDC, VSBY 5V5)
 PCI-E Channels
 General control signals (RTM PRESENT, RTM RST, LEDs)
 ATCA-7350 works with RTM-ATCA-7150
Fabric Channel Ports Reserved
 ATCA-7350 works with RTM-ATCA-7350
Fabric Channel Port 0, Port 1, Port 2, Port 3 (XAUI)
J15 uses a common 2mm HM connector. J29 uses a half-height ZD connector. J31 uses a ZD
connector.
The following table shows the J15 pinout. PinA1 on the server blade side is on the top of the
connector while the server blade is placed top side upwards and the face plate is left.
7 Unused Reserved Reserved Reserved Reserved Reserved Reserved Reserved Reserved
8 Reserved Reserved Reserved Reserved Reserved Reserved Reserved Reserved
9 Reserved Reserved Reserved Reserved Reserved Reserved Reserved Reserved
10 Reserved Reserved Reserved Reserved Reserved Reserved Reserved Reserved
Table 3-4 J23/P23 Connector Pin Assignments for ATCA-7350 (continued)
Pin
Interface
Designation
A B C D E F G H