Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 68)

Controls, LEDs and Connectors
ATCA-7350 Installation and Use (6806800G59G) 68
RTM_EN0_ and RTM_EN_ are signals that indicate the RTM is firmly inserted.
J29 is used for port1 and port2 signals of the Fabric interface, and the PCIE signals from MCH.
Table 3-5 J15 Pinout
HM A B C D E
1 VSB5V RTM_EN0 GND RTM_OOSR_ RTM_HEALTHY_G_
2 VSB5V RTM_HOTSPWAP_ GND RTM_HEALTHY_R RTM_OOSY_
3 +12V RTM_TOP_EJECTOR_ GND RTM_SDA RTM_SCL
4 +12V RT;_EPROM_WE GND VGA_RED CPLD_RTM_TDI
5 +12V RTM_BOT_EJECTOR_ GND VGA_BLUE RTM_JTAG_TDO
6 +12V RTM_KBCLK GND VGA_GREEN CPLD_RTM_TCK
7 +12V RTM_MSDAT GND VGA_HS CPLD_RTM_TMS
8 +12V RTM_MSCLK GND VGA_VS CPLD_RTM_TRST
9 +12V RTM_KBDAT GND VGA_DDCCLK RTM_PWR_GOOD
10 +12V RTM_USB_P GND VGA_DDCDAT RTM_LM80_INT_
11 +12V RTM_USB_N GND RTM_SBY_RST RTM_EN_
Table 3-6 J29 Pinout
ZD1 A B C D
1 RTM_SYSLED_G_ RESERVED GND RTM_SYSLED_R_ RESERVED GND
2 RTM_FC2_TX2_H RTM_FC2_TX2_L GND RTM_FC1_TX2_H RTM_FC1_TX2_L GND
3 RTM_FC2_RX2_H RTM_FC2_RX2_L GND RTM_FC1_RX2_H RTM_FC1_RX2_L GND
4 RTM_FC2_TX1_H RTM_FC2_TX1_L GND RTM_FC1_TX1_H RTM_FC1_TX1_L GND
5 RTM_FC2_RX1_H RTM_FC2_RX1_L GND RTM_FC1_RX1_H RTM_FC1_RX1_L GND
6 RTM_PE7_PRSNT_R_ RTM_PE7_RST_ GND MCH_EXP7_RXP3 MCH_EXP7_RXN3 GND
7 RTM_EXP7_RXP3 RTM_EXP7_RXN3 GND MCH_EXP7_RXP2 MCH_EXP7_RXN2 GND
8 RTM_EXP7_RXP2 RTM_EXP7_RXN2 GND MCH_EXP7_RXP1 MCH_EXP7_RXN1 GND
9 RTM_EXP7_RXP1 RTM_EXP7_RXN1 GND MCH_EXP7_RXP0 MCH_EXP7_RXN0 GND