Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 45)

Hardware Preparation and Installation
ATCA-7350 Installation and Use (6806800G59G) 45
2. Remove the ATCA-7350 whose DIMM is to be replaced.
For details, see Removing the ATCA-7350 on page 55 .
3. Open one fixing clip of the DIMM carefully until the DIMM rises from the interface. Hold the
top edge of the DIMM and open the other fixing clip carefully until the DIMM is removed
from the interface, as shown in
Figure 2-5 .
4. Take the DIMM out of the socket carefully, as shown in Figure 2-5 .
5. Place the extracted DIMM in the antistatic package.
6. Take the new DIMM out of the antistatic package.
7. Install the new DIMM.
For details, see Installing the DIMM on page 42 .
Product Damage
 To avoid breaking them or damaging the DIMM sockets, do not exert too much force to
operate the fixing clips.
 If you open the two fixing clips of the DIMM at the same time, the DIMM bounces from
the interface. Operate the fixing clips carefully to avoid damaging the DIMM.