Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 113)

System Management
ATCA-7350 Installation and Use (6806800G59G) 113
Before starting an SOL session, first make sure you can ping the ATCA-7350.
On the client, execute this command:
# ipmitool -I lanplus -L operator -H -U
solusername - P soluserpassword sol activate
If the SOL session is activated successfully, you get the following message:
[SOL Session operational. Use ~? for help]
Press and the target output should be displayed on your console.
If the SOL session does not activate, run this command and check how ipmitool is configured:
# ipmitool -I lanplus -L operator -H -U
solusername -P soluserpassword sol info
Checking SOL Configuration
On the client, there are two commands that can be issued to check the SOL configuration on
the Ethernet channels.
 On the client, use "ipmitool lan print 1" to display the configuration for the first Ethernet
channel.(This Ethernet port is connected to the Ethernet switch located in Slot #7 on the
chassis)
 On the client, use "ipmitool lan print 2" to display the configuration for the second Ethernet
channel.(This Ethernet port is connected to the Ethernet switch located in Slot #8 on the
chassis)
root@DRBlade14:/usr/bin# ipmitool lan print 1
Set in Progress : Set Complete
Auth Type Support : NONE MD2 MD5 PASSWORD
Auth Type Enable : Callback :
: User :
: Operator :
: Admin :