Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 196)

ATCA-7350 Installation and Use (6806800G59G)
Safety Notes
196
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense. Changes or
modifications not expressly approved by Artesyn Embedded Technologies Embedded
Computing could void the user's authority to operate the equipment. Board products are
tested in a representative system to show compliance with the above mentioned
requirements. A proper installation in a compliant system will maintain the required
performance. Use only shielded cables when connecting peripherals to assure that appropriate
radio frequency emissions compliance is maintained.
Operation
Damage of the Product
Surface of the Product
High humidity and condensation on the product surface causes short circuits.
Do not operate the product outside the specified environmental limits. Make sure the product
is completely dry and there is no moisture on any surface before applying power.
Do not operate the product below -5×C.
Overheating and Damage of the Product
Operating the product without forced air cooling may lead to overheating and thus damage of
the product.
When operating the product, make sure that forced air cooling is available in the shelf.
Configuration Jumpers
Malfunction of the Product
Reserved jumpers might carry production-related functions and can cause the product to
malfunction if their setting is changed.
Therefore, do not change settings of jumpers marked as "Reserved".