Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 40)

Hardware Preparation and Installation
ATCA-7350 Installation and Use (6806800G59G) 40
2.6.3 Preparations
Before you install or replace the component, make the following preparations:
 Confirming the feasibility of the operation
– There are available spare parts of the component to be installed or replaced in the
equipment warehouse. When the available spare parts are lacking, contact Artesyn
Embedded Technologies for help in time.
– Make sure that the new component is in good condition, without defects such as
oxidation, chemical corrosion, missing component, or transportation damage.
– By reading this document, you are familiar with how to install and replace the
component and master the skills required by the operation.
 Checking the environment
Make sure that the shelf, power supply, temperature, and humidity meet the operating
requirement for the blades and components. For details, refer to the respective system
documentation.
 Preparing spare parts and tools
– Prepare the component to be installed or replaced.
When you hold or transport the component, use the special antistatic package. Also,
you need to tidy, record, and repair the component during routine maintenance.
– Prepare the cross screwdriver, screws, plastic supports, cooling gel, and ESD-
preventive wrist strap.
The supplier provides a list of tools and negotiates with to decide the tool provider.
 Confirming installation or changing position
Confirm the positions of the cabinet, the shelf, and the slot where the ATCA-7350 is
installed. Then, stick a label on the face plate of the ATCA-7350 to avoid wrong operation.
 Others
If a serious problem occurs and cannot be solved when you install or replace the
component, contact Artesyn for technical support.