Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 198)

ATCA-7350 Installation and Use (6806800G59G)
Safety Notes
198
Artesyn Embedded Technologies Embedded Computing (ENPEC) and our suppliers take
significant steps to ensure there are no bent pins on the backplane or connector damage to the
boards prior to leaving the factory. Bent pins caused by improper installation or by inserting
boards with damaged connectors could void the ECC warranty for the backplane or boards.
Incorrect installation of the product can cause blade damage.
Only use handles for when installing/removing the product to avoid damage/deformation to
the face plate and/or PCB
Cabling and Connectors
Damage of the Product
The RJ-45 connector(s) on the face plate are either twisted-pair Ethernet (TPE) or E1/T1/J1
interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage the product.
 Make sure that TPE connectors near your working area are clearly marked as network
connectors.
 Verify that the length of an electric cable connected to a TPE bushing does not exceed 100
meters.
 Make sure the TPE bushing of the product is connected only to safety extra low voltage
circuits (SELV circuits).
If in doubt, ask your system administrator.
Laser
This product is a Class 1 laser product. The use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.
Environment
Always dispose of used blades, system components and RTMs according to your country’s
legislation and manufacturer’s instructions.