Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 57)

Hardware Preparation and Installation
ATCA-7350 Installation and Use (6806800G59G) 57
To remove RTM-ATCA-7x50, proceed as follows:
1. Wear the ESD-preventive wrist strap.
For details, see Wearing the ESD-Preventive Wrist Strap on page 34 .
2. Use the screwdriver to unfasten the captive screws anticlockwise, as shown in Figure 2-10 .
3. Fully open the upper and lower ejector handles, as shown in Figure 2-10 .
4. Remove RTM-ATCA-7x50 along the guide rails, as shown in Figure 2-10 .
5. Place RTM-ATCA-7x50 in the antistatic package.
For more information refer to the RTM-ATCA-7150 Installation and Use manual and RTM-ATCA-
7350 Installation and Use manual.
Figure 2-10 Removing RTM-ATCA-7x50