Artesyn ATCA-7350 Installation and Use (September 2014) - Manual (Page 52)

Hardware Preparation and Installation
ATCA-7350 Installation and Use (6806800G59G) 52
7. Fully open the ejector handles and the ATCA-7350 is ready for power-on. Before you power
on the ATCA-7350, connect the required external cables and check that the ATCA-7350 is
installed properly.
For the details on how to power on the ATCA-7350, see
Blade Power-On on page 53 .
2.7.1.2 Checking the Installation
After you install the RTM-ATCA-7x50 and ATCA-7350, and connect and bind cables, check
whether:
 The ATCA-7350 and RTM are installed in the paired slots.
 The upper and lower ejector handles of the RTM are fully closed.
 The cables are properly connected.
 The cables are well bound.
Figure 2-8 Installing the ATCA-7350